For a better experience please change your browser to CHROME, FIREFOX, OPERA or Internet Explorer.

Emergency Starting

If the engine doesn’t start:
  • Check the battery connection to make sure it is clean.
  • Turn the interior light on. If it is dim when you operate, the battery is out of charge.
  • Check the starter connection so that it is tightened.
  • Do not push/pull the vehicle to start. 
If the engine turns normally but does not start:
  • Check the fuel level.
  • When the ignition switch is off, check all the connectors, coils and spark plugs.
  • If any of them are loose or disconnected, reconnect them.
  • Check the fuel line present in the engine compartment.
If the engine doesn’t start:
  • Call a dealer or seek qualified assistance.
  • Connect the cables in either numerical order or disconnect them in reverse order
Jump starting procedure:
  • Assure that the booster battery is of 12-volt.
  • The negative terminal should be grounded.
  • If the booster battery is in another vehicle, do not allow these vehicles to touch. 
  • Turn off all the electrical loads.
Jump Cables:
  • Connect all the cables in a sequence – One end of the cable to the positive terminal of the battery and the other end to the positive end of the booster battery.
  • Connect one end of the negative terminal of the booster battery and the other end to the metallic point, stationary or a solid point away from the battery.
  • Do not connect it to any point if the engine is cranked.
  • Do not allow the cables to contact anything other than the terminals or the ground.
  • Do not lean over the battery.
  • Start the engine with a booster battery and run it at 2000 RPM.
  • Start the vehicle with the discharged battery. In case if it is not getting started, get it checked by an authorized dealer.
Battery cables:
  • Don’t connect the jumper cable from the negative terminal of the discharged battery to the negative terminal of the booster battery.
  • If you do it that way, the discharged battery can be overheated and releases battery acid.
Jumper System: 
  • You can only use a 12-volt jumper system. 
  • If you’re using a 24-volt power supply, you will damage the electrical parts.
Headlamp Changing:
  • Replace the burned-out bulb with one that has a wattage rating.
  • If it doesn’t have a rating, it will damage the electric wiring or the fuse.
  • Open the available bonnet.
  • Loosen the bolts and remove the assembly of the headlight from the main body.
  • Disconnect the connector from the back.
  • Remove the bulb cover by turning it in the opposite direction.
  • Disconnect the bulb socket connector.
  • Unsnap the bulb retaining wire by pressing at the end and pushing it up.
  • Remove the bulb.
  • Get a new bulb. Snap the bulb retaining wire into the exact position through alignment of the groove and the wire.
  • Connect the bulb socket connector.
  • Install the bulb cover by turning it clockwise.
  • Connect the power connector to the assembly.
  • Reinstall the headlight assembly to the main body.
Top
×

Hello!

Click one of our representatives below to chat on WhatsApp or send us an email to crm@bharatgroupe.com

× How can I help you?